How to identify your cabinet hinge mount

Open the door and look where the hinge fastens to the cabinet. First find out whether there’s a separate face frame. Then check which surface the plate and screws attach to.

Open cabinet hinge with the cabinet-side mounting plate at left and the round door-side cup at right
Look for the plate on the cabinet side and the hinge cup in the door. Photo by Dvortygirl · CC BY-SA 3.0

Compare where the plate sits

Look through the full opening to tell a separate face frame from the edge of a frameless panel. The top-view sketches show the cabinet’s front at the bottom. The orange mark shows where the plate sits. Use the product drawing for actual screw locations.

Frameless cabinet side

Cabinet side

The cabinet side runs right up to the front opening. The hinge plate sits on the wide inside surface of that panel.

See a frameless Blum replacement example

Face-frame edge mount

Frame edge

A separate frame surrounds the opening. The screws enter the inner edge of that frame, from the opening side.

Compare old Blum COMPACT edge plates

Face-frame wrap mount

Wrap plate

The mounting bracket bends around the frame corner. Compare where the bracket contacts the frame and which holes are used for your exact hinge.

See the Grass 830-13 wrap-mount fit check

Face-frame front mount

Front plate

The screws go straight into the visible front face of the frame. Compare plate height, the spacing between screws, and door clearance.

See Blum’s 38B face-mount drawing

Check how the cup fastens to the door

Look for wood screws going into pilot holes or plastic dowels that seat in larger bores. A visible screw head can also expand a dowel. Support the door and inspect behind a loose cup before choosing screw-on or press-in hardware.

Close view of the hinge arm and adjustment screw on an installed concealed cabinet hinge
The adjustment screw on the hinge arm is separate from the door and cabinet fasteners. Photo by Dvortygirl · CC BY-SA 3.0

Record the cup diameter and depth, the center-to-center spacing of the door fasteners, and the cabinet-side screw spacing. Compare both patterns with the replacement drawing before drilling.

See how to measure the cup and hole patterns

Match the mounting style and overlay together

If the new mounting holes differ, stop at the dry-fit. Some retrofits keep the cup bore but move the pilot holes. Check the procedure for your exact hinge and plate.

Source drawings